Side single sequin device bearing full-guiding type

1The sequin device can run 3mm,5mm,7mm,8mm,9mm sequins. 2The engine motor can be 0.5A or 1A 3The device is installed in side

Model:  DB-JP-18    B  (adjustable pressure spring type)

                 

Model : DB-JP-18     C  (pressure spring locking  type)

(1) : Use funtion

         1. It adopts precise combination of bearing and shaft to control up and down of the device

         2.Adjusting the bolt to move the motor board so that the sequin and needle hole alignment is convenient

         3.The special steel guide groove leads to the front of cutting blades so that the operation of changing blades can be simple and convenient

         4.The use of flat piece and concave piece will achieve the best effect

         5.Using the spiring piece to stop the back piece and the pressure can be adjustale,so that it doesn't hurt the sequin

         6.The device is installed in the side(the initial needle position or the end needle position)

 (2) : Technical parameters

         1.Space of sequin device: 80mm

         2.Lifting traveking: 30mm

         3.Sequin embroidery speed:

                ¢ 3mm --- 4mm --- ¢ 5mm           1000 r / min

                ¢ 6.75mm----- ¢ 9mm                   800 r / min

         4.Specification of sequin: ¢ 3mm, 4mm, ¢ 5mm, ¢ 6.75mm, ¢ 9mm,

         5. Specifications of stepping motor: 0.5A or 1A 

         6.The use of air pressure: 3kpa

Side single sequin device bearing full-guiding type